reviewjilo.blogg.se - Pvc projector screen stand

#Pvc projector screen stand how to
#Pvc projector screen stand movie

This stand was created to hold a 100 inch screen, provided in the TMY Projector with 100 Inch Screen set we purchased on Amazon.Otherwise the screen becomes a sail and the stand and screen could go flying. When it’s windy, you may want to anchor down the stand.We’ve had ours for several months and it still works fine, though. Although we used regular PVC Pipe, in the long term, it may have been better to use the electrical PVC pipe, since it’s a little more sturdy.This helps us put the screen on correct the first time. We color coded our hooks with a colored zip tie since our grommets are not symmetrical on our screen.

#Pvc projector screen stand movie

We’ve even taken it to my brother’s house for a movie night. Since all pieces are removable, you can collapse this stand easily for storage and reassemble whenever needed. Then drill the holes and hand twist the hooks in to secure to the pipe. Since screens vary, line up your screen grommets with the frame and using a marker, mark where your hooks need to be.Connect the four 2.5′ lengths on each side of the T Fitting on each leg.At the bottom of each of the 2′ length pieces, place another T Fitting.Next use the remaining 2′ lengths to come down from the screen.Use a T fitting on each of the bottoms of the 4’10” inch pieces to connect the remaining 8′ length for the bottom of the screen. Buy Projector Screen with Stand,100 inch Indoor Outdoor PVC Movie Projection Screen 4K HD 16: 9 Wrinkle-Free Design for Backyard Movie Night(Easy to Clean.Connect the 4’10” PVC lengths to the 8′ piece using the connected angles.Put the 90 degree angles at both ends of an 8′ PVC piece.

#Pvc projector screen stand how to

These will be the feet of the standįor your first assembly of this outdoor movie screen stand, we recommend using two people until you get the hang of how to assemble the stand.

Finally, cut the last 10′ PVC Pipe into 4 – 2.5′ lengths.

These 2 – 4’10” lengths become the left and ride sides of the screen stand. You will have 4′ leftover that you do not need.

Cut 1 of the 10′ PVC Pipes into 2 – 4’10” lengths.

These 8′ pieces will be the top and bottom of your screen stand. You can also use them to mount a projector screen. Hanging strips are commonly used to hang paintings, portraits, and mirrors. Hanging strips are very cheap and can hold up to 16 pounds of weight.

Cut 2 of the 10′ PVC Pipes into 8′ lengths, saving the 2′ remnants. Hanging Strips Another way to mount your projector screen without drilling holes is by hanging strips.

6 – Cup Hooks (depending on your screen) – note: 6 individual ones, not packs.

4 – 10 foot PVC Pipes, 1/2 inch diameter.